原帖由 shay 于 2008-6-22 19:00 发表 http://www.shoudian.org/images/common/back.gif
啊，超级中毒！！！
全滚花很不错，花了也不怎么明显！！！
这个外观实在太喜欢了
那位朋友有他的参数吗？
小弟只对aa感兴趣，嘻嘻～～
那个AA的应该和NDI参数一致，只是结构改成PD了
原帖由 funder 于 2008-6-22 23:11 发表 http://www.shoudian.org/images/common/back.gif
那个AA的应该和NDI参数一致，只是结构改成PD了
funder兄能具体一些吗？
小弟新手，望多多指点～
原帖由 qwqywl 于 2008-6-22 15:18 发表 http://www.shoudian.org/images/common/back.gif
仔细看，绳孔的倒角很细致，整体的加工精度希望会不错，等看更多的消息。
94845
外面的倒角做好一点也不希奇。。。。。里面如果也是倒角那就很不错了。。。。。不过。。几乎不可能有。。。。。。。
所以，所谓的一边倒角防割作用不大。。。。。。。:lol
funder兄能组织团购吗？
原帖由 shay 于 2008-6-22 23:14 发表 http://www.shoudian.org/images/common/back.gif
funder兄能具体一些吗？
小弟新手，望多多指点～
转贴自CPF的
*** UPDATED SUMMARY ***
1. 4sevens is building a new store to accommodate the new products
2. They are on the fenix-store web site so early testers can access them
3. They ARE NOT headlamps
4. Production is well underway
5. It will be Radical & Different (TM)
6. Release time should be 1-2 weeks
7. McGizmo was paid royalty for an aspect of the design
8. IT'S NOT A FENIX LIGHT!
9. The products aren't "pure 4Sevens lights" either
10. 4Sevens will have pre-production units with him @ SE Regional
11. They are not the same as LF5XT
12. Simple and intuitive design
13. Very pocket friendly
14. Initial run will be 500 pcs. of each
15. (Very) possibly a Nitecore flashlight
Early specs:
- 7075 military grade Al
- both models will use both primary (AA and CR123) as well as li-ion batteries (14500, rcr123)
- nickel-plated, "hard", piston drive button
- moderately aggressive knurling
- MCU controlled
- D10 is AA sized
- EX10 is CR123 sized
- EX10 will have a st. steel bezel (not shown on the photos)
- D10 3.5 x 0.75 in (8.89 x 1.91 cm)
- EX10 3.0 x 0.85 in (7.62 x 2.16 cm)
Leaked specs (taken down by OP as unconfirmed):
- unique electronic-controlled switch, very reliable
- continuous variable brightness, quick direct access min & max brightness
- HA Type III finish
- resistance to impact by dropping according to US MIL-STD-810F
- waterproof to IPX-8 standard
- 130 torch lumens
- metal reflector
- impact-resistant optical lens with Dual-Coating
- tactical lanyards braided with military grade 550 parachute-cord
Leaked UI description (taken down by OP as unconfirmed):
- From OFF:
Click, Click, Click = On directly to low
Click, Click, Click-hold = On directly to high
Click once = Last level used
- From ON:
Click, click = Min brightness
Click, click-hold = Max brightness
Press-hold = Ramping (reverses if you do it again)
Click once = Off
- For Momentary, loosen the bezel.
原帖由 承谦堂主 于 2008-6-22 23:47 发表 http://www.shoudian.org/images/common/back.gif
funder兄能组织团购吗？
不能，抱歉
另外一个所谓泄露参数表
Features:
Unique electronic-controlled switch, very reliable;
Unique Infinitely Variable Digital-controlled Brightness System;
Quick direct access min & max brightness, very simple user interface;
Made from military grade aluminum alloy, really strong;
Extremely compact size and light weight suitable for EDC (every day carry);
Mil-Spec Type III Hard Anodized finish;
Resistance to impact by dropping according to US MIL-STD-810F;
Waterproof to IPX-8 standard;
Broad-voltage fully-regulated circuit, compatible with kinds of batteries;
Built in high efficiency LED (Light Emitting Diodes);
Torch Lumen 130 lumens;
Extended runtime;
Metal reflector;
Impact-resistant optical lens with Dual-CoatingTM technique;
Tactical lanyards braided with military grade 550 parachute-cord;
Tail stand.
FIRST TIME USE
Insert Battery
Please follow the instruction of the diagram below to insert the battery correctly,
and screw back the tail cap tight.
CAUTION:
1. This product can be powered by one battery or other types of batteries of the
same size (D10- 1 AA battery , EX10- 1 CR123 battery).
2. Please be cautious to insert battery with the positive end toward LED assembly.
Misplacement of the battery polarity may cause damages to the flashlights.
3. Please DO NOT use rechargeable Li-ion batteries without Safety Circuits.
Light Activation
Put in one battery and screw back the light body tight, the light is ON. Click the tail
cap once, the light is OFF. Click the tail cap another time to ON the light again.
Brightness Choosing
When the light is ON, depress the tail cap and hold for more than 0.5 second, the
brightness performs from Max to Min or Min to Max. When certain brightness is
desired, release to stop brightness ramping and certain brightness level
memorized. If depress and hold the tail cap, the light performs brigtness ramping
reversely.
Tips: When the light is on Max or Min brightness level, you depress and hold, it
could happen sometimes that the brightness do not change. This is because the
Max or Min is the end level of certain brightness ramping. (For example, when the
light is on Max, and the brightness ramping is from Min to Max; Or, when the light is
on Min, and the brightness ramping is from Max to Min.) At this moment, users
need to release, depress and hold the tail cap another time to activate brightness
ramping.
Direct Access to Max or Min brightness
For convenient daily use, D10TM & EX10 TM provide directly access to Max or Min
brightness whenever needed.
When the light is ON, quick double-click the tail cap, the light enters Min brightness
directly.
When the light is ON, quick double-click the tail cap and hold, the light enters Max
brightness directly.
Tips: To enter Min or Max brightness when the light is OFF, users need only click
the tail cap one more time. For example, when the light is OFF, quick triple-click
the tail cap continuously, the light enters Min brightness directly. When the light is
OFF, quick triple-click the tail cap continuously and hold, the light enters Max
brightness directly.
Momentary On & Safety Lock-out
Loosen the light bezel about one circle, the light enters momentary on mode.
Under this mode, depress the tail cap to ON and release to OFF the light.
Tips:
1. When under momentary on mode, depress the tail cap and hold for more
than 0.5 second, the light enters Max brightness directly.
2. Loosen the light bezel about one circle also lock out the light and avoids
accidental activation of the light (permanent bright). If users need to carry
the light often and for long, or to put them in backpacks for transportation,
please set the light at momentary on mode.
Output & Runtime
D10:
AA battery
Maximum output 130 lumens, for about 50 minutes (with brightness declines to 50%)
Minimum output 3 lumens(1%), for about 45 hours (with brightness declines to 50%)
Li-ion Battery
Maximum output 130 lumens, for about 80 minutes (with brightness declines to 50%)
Minimum output 5 lumens(1%), for about 60 hours (with brightness declines to 50%)
EX10:
CR123 battery
Maximum output 130 lumens, for about 90 minutes (with brightness declines to 50%)
Minimum output 3 lumens(1%), for about 65 hours (with brightness declines to 50%)
Li-ion Battery
Maximum output 130 lumens, for about 80 minutes (with brightness declines to 50%)
Minimum output 5 lumens(1%), for about 60 hours (with brightness declines to 50%)
鸡肠不好,,,,,能翻译一下吗:handshake
很想收一只！！！
原帖由 funder 于 2008-6-22 23:50 发表 http://www.shoudian.org/images/common/back.gif
转贴自CPF的
*** UPDATED SUMMARY ***
1. 4sevens is building a new store to accommodate the new products
2. They are on the fenix-store web site so early testers can access them
3. They ARE NOT head ...
谢谢兄弟提供的信息
哪位筒友组织一下团购？
已经正式公布了：
http://www.cpfmarketplace.com/mp/showthread.php?t=180233&page=2
其实也不要急，等评测出来再看吧
古怪的創意(這句是讚美). 希望不要又漏水吧..... :lol
http://www.youtube.com/watch?v=irqhuV8Xo_A&locale=en_US&persist_locale=1
不鏽鋼內膽, 這樣外殼應該有點薄. 萬一掉落變形就慘了. 會卡住.
外筒和內筒間也要潤滑. 總覺得內筒真是應該要雙O圈設計(可是又會影響阻尼)
總算放棄了暴閃. 可是點亮和長亮之間轉換又要轉燈頭, 恐怕單手操作有夠彆扭的. 放棄了尾蓋是進步(省工本費, 哈), 但也要不少妥協.
感覺是為了打入國外市場的玩具筒. 放棄了戰術這個戰術那個的口號, 可是方便來說..... :L
[ 本帖最后由 V_Gore 于 2008-6-23 13:06 编辑 ]
我是有兴趣买一个。假如方便的话。
PD结构和开关结构各有利弊，V_core兄分析的都很有道理，这些问题在原版的PD上也存在，所以Clicky和PD结构谁也不能取代谁。
厂商愿意想新点子，玩家愿意花钱买单，手电发烧不就这么回事嘛:lol :lol
原来是这样，撤退！
太喜欢了～～
原帖由 funder 于 2008-6-23 13:08 发表 http://www.shoudian.org/images/common/back.gif
PD结构和开关结构各有利弊，V_core兄分析的都很有道理，这些问题在原版的PD上也存在，所以Clicky和PD结构谁也不能取代谁。
厂商愿意想新点子，玩家愿意花钱买单，手电发烧不就这么回事嘛:lol :lol ...
說老實話, 我真是一個很守舊的人. 基本上意識還在九十年代末期:L . 尤其在一些簡單工具上面.